Open Source Power Bar
THIS PROJECT IS NOT READY, YET.
A DIY Power Bar project, that requires no soldering, is easy to build and all parts are sourced on eBay or Aliexpress.
It is powered by Arduino nano, runs Firmata and can be controlled over serial (USB or Bluetooth). Comes complete, with Firmware, build instructions and a software to communicate with the Board.
It was originally designed for use with Aquarium Controllers, like the Reefmate from Invent Marine and Reef Angel, it can also be used by anyone willing to control 220/110V power sockets.
Bill of materials
- 8 relays board
- 1 Enclosure: $7
- 8 extension cables: $16
- 1 Arduino nano: $5
- 1 Power cable:
- 1 power cable connector:
- SVGA breakout board:
- Scres
- Flat cable Aprox. cost: ??
Build steps
Install the firmware
To be done
Assembling
To be done
Running the software
To be done
Notice
Playing with high voltage is dangerous and can kill or cause fires, becarefull and don't attempt it unless you know what you are doing. It is also illegal in some countries, like Australia and can void your home insurance.
Sponsor
This project is proudly sponsored by Invent Marine
Contributors
@fsamir - Franklin Dattein